unit power supplies GPSA series -Feature

Specification

GPSA-360 Series

Items		Specification					Measurement conditions, etc.
Rated voltage		AC100-240V(AC85*-264V)					Worldwide range Derating for Low Input Voltage(link*)
Input frequency		50/60Hz					47-63Hz
Efficiency		80% typ(AC100V),83% typ(AC200V)					With rated output
Power factor		96% min (AC100V),90% min(AC200V)
Inrush current		31A peak(AC100V),75A peak(AC240V)					With rated input/output at cold start(25℃)
Input current		4.5A typ（AC100V）,1.8A typ（AC240V）					With rated input and max output
		5.1A typ（AC100V）,2.1A typ（AC240V）					With rated input and peak output
Model		GPSA-360-12-TP	GPSA-360-24-TP	GPSA-360-30-TP	GPSA-360-48-TP	Common for all models
Rated voltage		+12V	+24V	+30V	+48V	+12VSB
Rated current/power		30A	15A	12A	7.5A	0.1A
		360W	360W	360W	360W	1.2W
Peak current/power		34A	17A	13.6A	8.5A	0.1A	Time shall be 5s max. For repetitive loads, duty ratio shall be 10% max(link*)
		408W	408W	408W	408W	1.2W
Minimum current		0A	0A	0A	0A	0A
Setup voltage at shipment		12V±2%	24V±2%	Coming Soon		12V±10%	The values shall be measured at output terminal block or connector.
Adjustable voltage range		12V±10%	24V -5%,+20%			－
Static input regulation		48mV max	96mV max			120mV max
Static load regulation		100mV max	150mV max			600mV max
Time lapse drift-		48mV max	96mV max			120mV max
Temperature regulation		0.02%/℃ max	0.02%/℃ max			0.02%/℃ max
Max ripple voltage (mVp-p)	-10〜0℃	160 max	160 max			120 max	onnect two wires of 100cm max to the output terminal block and put a 47µF electrolytic capacitor and a 0.1µF ceramic capacitor. Put a 100MHz oscilloscope to measure.
	0〜60℃	120 max	120 max			120 max
Max spike voltage (mVp-p)	-10〜0℃	180 max	180 max			180 max
	0〜60℃	150 max	150 max			150 max
Over Current Protection	OCP point (A)	101% min of peak rated current				101% min of peak current	Other outputs have rated output and rated input.
	Method	Hold-down current limiting→output shutdown				Hold-down current limiting
Recovery (OC)	AC operation	Reclosing AC input				Automatic recovery
Over Voltage Protection	OVP point （V）	13.8 to 16.2	29.2 to 35.0			－
	Method	Output shutdown				－
Recovery (0V)	At AC operation	Reclosing AC input				－
Operating temperature/humidity		-10〜60℃*/10〜90%					Temperature Derating(link*) There shall be no condensation.
Storage temperature/humidity		-25〜75℃/10〜95%					There shall be no condensation.
Vibration		Acceleration of 2G, vibration frequency of 10-55Hz, 10 sweep cycles in the X･Y･Z directions.					JIS-C-60068-2-6
Mechanical shock		Lift one bottom edge up to 50mm and let it fall. Repeat three times for each of four edges. No malfunction.					JIS-C-60068-2-31, at no operation
Dielectric strength		AC 4000V for one minute between AC input and DC output AC 2000V for one minute between AC input and FG					Perception current is 10mA. Completion inspection: AC3000V/min between AC input-DC output
Insulation resistance		50MΩ min between AC input and DC output 50MΩ min between AC input and FG 50MΩ min between DC output and FG					DC500V
Leakage current		0.21mA max (AC100V)/0.5mA max (AC240V)					YEW. TYPE3226 (1kΩ) or equivalent
Line noise immunity		±2000V （pulse width: 100ns and 1000ns, repetitive cycle: 30-100Hz, normal and common modes with positive and negative polarities for 10 minutes each.					Measured with INS-410. There shall be no fluctuation of DC output or malfunction.
Electrostatic discharge		EN61000-4-2 compliant
Radiated,radio-frequency EM field		EN61000-4-3 compliant
Fast transient burst		EN61000-4-4 compliant
Lightning surge		EN61000-4-5 compliant
Conducted disturbances induced by radio-frequency		EN61000-4-6 compliant
Power source frequency magnetic field		EN61000-4-8 compliant
Voltage dip/regulation		EN61000-4-11 compliant
Conducted emission		VCCI-B, FCC-B, EN55022-B, and CISPR22-B compliant					Measured with power supply single body
Harmonic current regulation		IEC61000-3-2（Ver 2.1） Class D compliant					With rated input and output
Safety standard		UL60950-1, CSA60950-1（c-UL）,EN60950-1, EN60601-1, EN50178 scheduled to acquire					In May 2009 (GPSA-360-12-TP and GPSA-360-24-TP only)
Cooling system		Forced-air cooling
Output GND terminal		Capacitor grounded
Output hold-up time		PWR_OK holds up 20ms minimum after AC failure.					With rated output
Reliability Grade		FA （Industrial equipment grade, double-sided PWBs with through holes）					It is to follow our standard.
MTBF		70,000 H min					Based on EIAJ RCR-9102
Weight		1.4 kg typ
Warranty		Three years after delivery. If any faults belong to us, the defective unit shall be repaired or replaced at out cost.					Except for errors caused by operations not listed.

TOP

GPSA-750 Series

Items		Specification					Measurement conditions, etc.
Rated voltage		AC100-240V(AC85*-264V)					Worldwide range Derating for Low Input Voltage(link*)
Input frequency		50/60Hz					47-63Hz
Efficiency		81% typical (AC100V),84% typical (AC200V)					With rated output
Power factor		96% typical(AC100V),90% typical(AC200V)
Inrush current		31A peak(AC100V),75A peak(AC240V)					With rated input/output at cold start（25℃）
Input current		8.8A typ（AC100V）,3.6A typ（AC240V）					With rated input and max output
		10.2A typ（AC100V）,4.2A typ（AC240V）					With rated input and peak output
Model		GPSA-750-12-TP	GPSA-750-24-TP	GPSA-750-30-TP	GPSA-750-48-TP	Common for all models
Rated voltage		+12V	+24V	+30V	+48V	+12VSB
Rated current/power		56A	30A	25A	16A	0.1A
		768W	768W	768W	768W	1.2W
Peak current/power		70A	35A	28A	17.5A	0.1A	*Time shall be 5s max. For repetitive loads, duty ration shall be 10% max
		840W	840W	840W	840W	1.2W
Minimum current		0A	0A	0A	0A	0A
Setup voltage at shipment		12V±2%	24V±2%	Coming Soon		12V±10%	The values shall be measured at output terminal block or connector.
Adjustable voltage range		12V±10%	24V -5%,+20%			－
Static input regulation		48mVmax	96mV max			120mV max
Static load regulation		240mV max	240mV max			600mV max
Time lapse drift-		60mV max	120mV max			120mV max
Temperature regulation		0.02%/℃ max	0.02%/℃ max			0.02%/℃ max
Max ripple voltage (mVp-p)	-10〜0℃	160 max	160 max			120 max	Connect two wires of 100cm max in length to the output terminal block and put a 47µF electrolytic capacitor and a 0.1µF ceramic capacitor. Put a 100MHz oscilloscope to measure.
	0〜60℃	120 max	120 max			120 max
Max spike voltage (mVp-p)	-10〜0℃	180 max	180 max			180 max
	0〜60℃	150 max	150 max			150 max
Over Current Protection	OCP point (A)	101% minimum of peak current				101% min peak current
	Method	Hold-down current limiting→output shutdown				Hold-down current limiting
Recovery (OC)	AC operation	Reclosing AC input				Automatic recovery
Over Voltage Protection	OVP point （V）	13.8 to 16.2	29.2 to 35.0			－
	Method	Output shutdown				－
Recovery (0V)	At AC operation	Reclosing AC input				－
Operating temperature/humidity		-10〜60℃*/10〜90%					Temperature Derating(link*) There shall be no condensation.
Storage temperature/humidity		-25〜75℃/10〜95%					There shall be no condensation.
Vibration		Acceleration of 2G, vibration frequency of 10-55Hz, 10 sweep cycles in the X･Y･Z directions.					JIS-C-60068-2-6 at no operation
Mechanical shock		Lift one bottom edge up to 50mm and let it fall. Repeat three times for each of four edges. No malfunction.					JIS-C-60068-2-31, at no operation
Dielectric strength		AC4000V for one minute between AC input and DC output AC2000V for one minute between AC input and FG					Perception current is 10mA. Completion inspection:AC3000V/min between AC input-DC output
Insulation resistance		50MΩ minimum between AC input and DC output 50MΩ minimum between AC input and FG 50MΩ minimum between DC output and FG					DC500V
Leakage current		0.21mA max(AC100V)/0.5mA max(AC240V)					YEW. TYPE3226 (1kΩ) or equivalent.
Line noise immunity		±2000V （pulse width: 100ns and 1000ns, repetitive cycle: 30-100Hz, normal and common modes with positive and negative polarities for 10 minutes each）					Measured with INS-410. There shall be no fluctuation of DC output or malfunction.
Electrostatic discharge		EN61000-4-2 compliant
Radiated,radio-frequency EM field		EN61000-4-3 compliant
Fast transient burst		EN61000-4-4 compliant
Lightning surge		EN61000-4-5 compliant
Conducted disturbances induced by radio-frequency		EN61000-4-6 compliant
Power source frequency magnetic field		EN61000-4-8 compliant
Voltage dip/regulation		EN61000-4-11 compliant
Conducted emission		VCCI-B, FCC-B, EN55022-B, and CISPR22-B compliant					Measured with power supply single body.
Harmonic current regulation		IEC61000-3-2（Ver.2.1） Class D, EN61000-3-2(A14) Class D compliant					With rated input and output
Safety standard		UL60950-1,CSA60950-1(c-UL),EN60950-1,EN60601-1,EN50178 scheduled to acquire.					In May 2009 (GPSA-750-12-TP and GPSA-750-24-TP only)
Cooling system		Forced-air cooling
Output GND terminal		Capacitor grounded
Output hold-up time		PWR_OK holds up 20ms min after AC failure.					With rated output
Reliability Grade		FA （industrial equipment grade, double-sided PWBs with through holes）					It is to follow our standard.
MTBF		70,000 H min					Based on EIAJ RCR-9102
Weight		2.3 kg typ
Warranty		Three years after delivery. If any faults belong to us, the defective unit shall be repaired or replaced at out cost.					Except for errors caused by operation not listed.

TOP